An elevated base material temperature may lead to a reduction of the design bond resistance. 09 /ģ Service temperature range Hilti HIT-HY 150 MAX injection mortar may be applied in the temperature ranges given below. The partial safety factors for action depend on the type of loading and shall be taken from national regulations. The corresponding load values can be calculated according to the simplified design method. Embedment depth h ef = h b) ef,typ Base material thickness h a) The allowed range of embedment depth is shown in the setting details. Mean ultimate resistance, characteristic resistance, design resistance, recommended loads. long ter m/short term base material temperature: +24 C/40 C) - Installation temperature range -10 C to +40 C / 2012Ģ Embedment depth a) and base material thickness for the basic loading data. date of issue European technical approval a) DIBt, Berlin ETA-08/0352 / a) All data given in this section according ETA-08/0352 issue Basic loading data (for a single anchor) All data in this section applies to For details see Simplified design method - Correct setting (See setting instruction) - No edge distance and spacing influence - Steel failure - Base material thickness, as specified in the table - One typical embedment depth, as specified in the table - Anchor material: rebar BSt 500 S - Concrete C 20/25, f ck,cube = 25 N/mm² - Temperate range I (min.
#HILTI ANCHORS HIT HX 150MAX SD CRACKED#
1 Hilti HIT-HY 150 MAX Injection mortar system Hilti HIT- HY 150 MAX 330 ml foil pack (also available as 500 ml and 1400 ml foil pack) Static mixer rebar BSt 500 S Benefits - suitable for non-cracked and cracked concrete C 20/25 to C 50/60 - suitable for dry and water saturated concrete - high loading capacity - rapid curing - small edge distance and anchor spacing possible - large diameter applications - in service temperature range up to 120 C short term/72 C long term - manual cleaning for anchor size Ø8 to Ø14 and embedment depth h ef 10d for non-cracked concrete - embedment depth range: from mm for Ø8 to mm for Ø25 Concrete Tensile zone Small edge distance and spacing Variable embedment depth European Technical Approval CE conformity PROFIS Anchor design software Approvals / certificates Description Authority / Laboratory No.